Dell PowerSwitch S5212F-ON OS10 Enterprise Edition User Guide Release 10.4.3.0 - Page 284

Supported Releases 10.2.0E or later lacp rate Sets the rate at which LACP sends control packets. Syntax Parameters lacp rate {fast | normal} • fast - Enter the fast rate of 1 second. • normal - Enter the default rate of 30 seconds. Default Command Mode Usage Information Example 30 seconds INTERFACE Change the LACP timer rate to modify the duration of the LACP timeout. The no version of this command resets the rate to the default value. OS10(conf-range-eth1/1/7-1/1/8)# lacp rate fast Supported Releases 10.2.0E or later lacp system-priority Sets the system priority of the device for LACP. Parameters priority - Enter the priority value for physical interfaces (0 to 65535). Default 32768 Command Mode CONFIGURATION Usage Information Each device that runs LACP has an LACP system priority value. LACP uses the system priority with the MAC address to form the system ID and also during negotiation with other systems. The system ID is unique for each device. The no version of this command resets the system priority to the default value. Example OS10(config)# lacp system-priority 32768 Supported Releases 10.2.0E or later show lacp counter Displays information about LACP statistics. Syntax Parameters show lacp counter [interface port-channel channel-number] • interface port-channel - (Optional) Enter the interface port-channel. • channel-number - (Optional) Enter the LACP channel group number (1 to 128). Default Command Mode Usage Information Not configured EXEC All channel groups display if you do not enter the channel-number parameter. 284 Layer 2