Dell PowerSwitch S5212F-ON OS10 Enterprise Edition User Guide Release 10.4.3.0 - Page 42

Reason : ZTD process completed successfully at Mon Jul 16 19:31:57 2018 OS10# show ztd-status ZTD Status : disabled ZTD State : failed Protocol State : idle Reason : ZTD process failed to download post script file • ZTD Status - Current operational status: enabled or disabled. • ZTD State - Current ZTD state: initialized, in-progress, successfully completed, failed, or canceled while in progress. • Protocol State - Current state of ZTD protocol: initialized, idle while waiting to enable or complete ZTD process, waiting for DHCP post-hook callback, downloading files, installing image, executing pre-config or postconfig CLI commands, or executing post-ZTD script file. • Reason - Description of a successful or failed ZTD process. Supported Releases 10.4.1.0 or later ztd cancel Stops ZTD while in progress. After you cancel ZTD, you can enter CLI commands to configure the switch. Syntax ztd cancel Parameters None Default ZTD is enabled. Command Mode EXEC Usage Information When ZTD is enabled, the command-line interface is locked. You cannot enter OS10 configuration commands. Use the ztd cancel command to cancel the ZTD process and return to CLI configuration mode. You can enter ztd cancel only when ZTD is in a waiting state; that is, before it receives an answer from the DHCP server. Otherwise, the command returns an error message. Example OS10# ztd cancel Supported Releases 10.4.1.0 or later Remote access You can remotely access the OS10 command-line interface (CLI) and the Linux shell. When you install OS10 the first time, connect to the switch using the serial port. Configure remote access • Configure the Management port IP address • Configure a default route to the Management port • Configure a user name and password Remote access OS10 CLI 1 Open an SSH session using the IP address of the device. You can also use PuTTY or a similar tool to access the device remotely. ssh admin@ip-address password: admin 42 Getting Started