Dell Vostro 5402 Service Manual - Page 57
Installing the I/O board - UMA
![]() |
View all Dell Vostro 5402 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
Steps 1. Locate the I/O board on your computer. 2. Lift the mylar cover. 3. Peel the adhesive tape to unroute the I/O cable. 4. Open the latch, and disconnect the I/O-board cable from the I/O board. 5. Remove the two screws (M2.5x4) and (M2x3) that secure the left display hinge to the computer. 6. Open the latch, and disconnect the fingerprint reader cable from the I/O board. 7. Remove the three screws (M2x3) that secure the I/O board to the palm-rest and keyboard assembly. 8. Lift the I/O board off the palm-rest and keyboard assembly. Installing the I/O board - UMA Prerequisites If you are replacing a component, remove the existing component before performing the installation procedure. About this task The figure indicates the location of the I/O board and provides a visual representation of the installation procedure. Disassembly and reassembly 57
![](/manual_guide/products/dell-vostro-5402-service-manual-737d4f2/57.png)