Dell W-Series 207 Instant 6.5.1.0-4.3.1.0 User Guide - Page 105
Configuring VLAN for a Wired Profile
View all Dell W-Series 207 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 105 highlights
information on assigning a wired network profile to a port, see Assigning a Profile to Ethernet Ports on page 109. c. Spanning Tree-Select the Spanning Tree check box to enable Spanning Tree Protocol (STP) on the wired profile. STP ensures that there are no loops in any bridged Ethernet network and operates on all downlink ports, regardless of forwarding mode. STP will not operate on the uplink port and is supported only on W-IAPs with three or more ports. By default, Spanning Tree is disabled on wired profiles. d. Inactivity Timeout-Specify the time out interval within the range of 60-86,400 seconds for inactive wired clients. The default interval is 1000 seconds. 5. Click Next. The VLAN tab details are displayed. 6. Configure VLAN for the wired profile. For more information, see Configuring VLAN for a Wired Profile on page 105. In the CLI To configure the settings for a wired profile: (Instant AP)(config)# wired-port-profile (Instant AP)(wired ap profile )# type {|} (Instant AP)(wired ap profile )# speed {10|100|1000|auto} (Instant AP)(wired ap profile )# duplex {half|full|auto} (Instant AP)(wired ap profile )# no shutdown (Instant AP)(wired ap profile )# poe (Instant AP)(wired ap profile )# uplink-enable (Instant AP)(wired ap profile )# content-filtering (Instant AP)(wired ap profile )# spanning-tree (Instant AP)(wired ap profile )# end (Instant AP)# commit apply Configuring VLAN for a Wired Profile If you are creating a new wired profile, complete the Wired Settings procedure before configuring the VLAN settings. For more information, see Configuring Wired Settings on page 104. You can configure VLAN using the Instant UI or the CLI. In the Instant UI To configure a VLAN: 1. In the VLAN tab, enter the following information. a. Mode-You can specify any of the following modes: l Access-Select this mode to allow the port to carry a single VLAN specified as the native VLAN. l Trunk-Select this mode to allow the port to carry packets for multiple VLANs specified as allowed VLANs. b. Specify any of the following values for Client IP Assignment: l Virtual Controller Assigned: Select this option to allow the VC to assign IP addresses to the wired clients. When the VC assignment is used, the source IP address is translated for all client traffic that goes through this interface. The VC can also assign a guest VLAN to a wired client. l Network Assigned: Select this option to allow the clients to receive an IP address from the network to which the VC is connected. On selecting this option, the New button to create a VLAN is displayed. Create a new VLAN if required. c. If the Trunk mode is selected: l Specify the VLAN in Allowed VLAN, enter a list of comma separated digits or ranges, for example, 1,2,5 or 1-4, or all. The Allowed VLAN refers to the VLANs carried by the port in Access mode. 105 | Wired Profiles Dell Networking W-Series Instant 6.5.1.0-4.3.1.0 | User Guide