Dell W-Series 207 Instant 6.5.1.0-4.3.1.0 User Guide - Page 402

Table 85: W-IAP Configuration for Scenario 2-IPsec: Single Datacenter with Multiple controllers for Redundancy Configuration Steps CLI Commands UI Procedure (Instant AP)(SSID Profile "guest")# auth-server server1 (Instant AP)(SSID Profile "guest")# auth-server server2 (Instant AP)(SSID Profile "guest")# captive-portal internal 8. Create access rule for wired and wireless authentication. In this example, the rule permits all traffic. NOTE: This example uses internal captive portal use case using external authentication server. You can also use an external captive portal example. NOTE: The SSID type guest is used in this example to enable configuration of captive portal. However, corporate access through VPN tunnel is still allowed for this SSID because the VLAN associated to this SSID is a VPN-enabled VLAN (20 in this example). For wired profile: (Instant AP)(config)# wlan access-rule wired-port (Instant AP)(Access Rule "wired-port")# rule any any match any any any permit For WLAN SSID: (Instant AP)(config)# wlan access-rule guest (Instant AP)(Access Rule "guest")# rule any any match any any any permit See Configuring ACL Rules for Network Services NOTE: Ensure that you execute the commit apply command in the Instant CLI before saving the configuration and propagating changes across the W-IAP cluster. W-IAP-Connected Switch Configuration Client VLANs defined in this example must be opened on the upstream switches in multiple W-IAP deployments, as client traffic from the slave to the master is tagged with the client VLAN. Datacenter Configuration For information on controller configuration, see Configuring a Controller for IAP-VPN Operations on page 243. Ensure that the upstream router is configured with a static route pointing to the controller for the L3 VLAN. Dell Networking W-Series Instant 6.5.1.0-4.3.1.0 | User Guide IAP-VPN Deployment Scenarios | 402