Dell W-Series 207 Instant 6.5.1.0-4.3.1.0 User Guide - Page 59

Table 17: System Parameters Parameter URL Visibility Cluster security Virtual Controller network settings Description CLI Configuration l All-Displays both App and WebCC DPI data. l None-Does not display any AppRF content. Select Enabled or Disabled from the URL visibility (Instant AP)(config) drop-down list. # url-visibility Select Enabled to ensure that the control plane messages between access points are secured. This option is disabled by default. NOTE: The Cluster security setting can be enabled only if the default NTP server or a static NTP server is reachable. (Instant AP)(config) # cluster-security If the VC IP address is in the same subnet as the WIAP, ensure that you select Custom from the Virtual Controller network settings drop-down list and configure the following details: l Virtual Controller Netmask-Enter subnet mask details. l Virtual Controller Gateway-Enter a gateway address. l Virtual Controller DNS-If the DNS IP address is configured for a master W-IAP, the DNS IP settings are synchronized for all APs in a W-IAP cluster. (Instant AP)(config) # virtualcontroller-dnsip (Instant AP)(config) # virtualcontroller-vlan l If the DNS IP address is configured for a WIAP as part of the per W-IAP setting (Edit Access Point > General), it takes precedence over the VC DNS IP address defined in the System > General window. l If the W-IAPs are not explicitly assigned a DNS IP address, the DNS IP address defined in System > General takes precedence. l If the DNS IP address is not defined for WIAPs or VC, the DNS address dynamically assigned from the DHCP server is used. l Virtual Controller VLAN-Ensure that the VLAN defined for the VC is not the same as the native VLAN of the W-IAP. VC VLAN, gateway, and subnet mask details. 59 | Initial Configuration Tasks Dell Networking W-Series Instant 6.5.1.0-4.3.1.0 | User Guide