Dell W-Series 207 Instant 6.5.1.0-4.3.1.0 User Guide - Page 184

f. If required, enable other parameters such as Log, Blacklist, Classify media, Disable scanning, DSCP tag, and 802.1p priority. g. Click OK. 5. Click Finish. In the CLI To configure destination-NAT access rule: (Instant AP)(config)# wlan access-rule (Instant AP)(Access Rule "")# rule dst-nat ip [] (Instant AP)(Access Rule "")# end (Instant AP)# commit apply Configuring ALG Protocols You can enable or disable protocols for Application Layer Gateway (ALG) using the Instant UI or the CLI. In the Instant UI To enable or disable ALG protocols: 1. Click the Security link located directly above the Search bar on the Instant main window. 2. Click the Firewall Settings tab. The Firewall Settings tab contents are displayed. The following figure shows the contents of the Firewall Settings tab: Figure 40 Firewall Settings-ALG Protocols 3. Select Enabled from the corresponding drop-down lists to enable SIP, VOCERA, Alcatel NOE, and Cisco Skinny protocols. 4. Click OK. When the protocols for ALG are set to Disabled, the changes are not applied until the existing user sessions expire. Reboot the W-IAP and the client, or wait for a few minutes to view the changes. In the CLI To configure protocols for ALG: (Instant AP)(config)# alg (Instant AP)(ALG)# sccp-disable (Instant AP)(ALG)# no sip-disable (Instant AP)(ALG)# no ua-disable (Instant AP)(ALG)# no vocera-disable (Instant AP)(ALG)# end (Instant AP)# commit apply Dell Networking W-Series Instant 6.5.1.0-4.3.1.0 | User Guide Roles and Policies | 184