Dell W-Series 207 Instant 6.5.1.0-4.3.1.0 User Guide - Page 25

Configuring Managed Mode Parameters To enable the automatic configuration, perform the steps described in the following table: Table 9: Managed Mode Commands Steps Command 1. Start a CLI session to configure the managed-mode profile for automatic configuration. (Instant AP)(config)# managed-mode-profile 2. Enable automatic configuration Or Specify the user credentials. (Instant AP)(managed-mode-profile)# automatic Or (Instant AP)(managed-mode-profile)# username (Instant AP)(managed-mode-profile)# password NOTE: If the automatic mode is enabled, the user credentials are automatically generated based on W-IAP MAC address. 3. Specify the configuration file. (Instant AP)(managed-mode-profile)# config-filename Filename-Indicates filename in the alphanumeric format. Ensure that configuration file name does not exceed 40 characters. 4. Specify the configuration file download method. (Instant AP)(managed-mode-profile)# download-method You can use either FTP or FTPS for downloading configuration files. 5. Specify the name of the server or the IP address of the server from which the configuration file must be downloaded. (Instant AP)(managed-mode-profile)# server 25 | Automatic Retrieval of Configuration Dell Networking W-Series Instant 6.5.1.0-4.3.1.0 | User Guide