Dell W-Series 207 Instant 6.5.1.0-4.3.1.0 User Guide - Page 56
Initial Configuration Tasks, Configuring System Parameters
![]() |
View all Dell W-Series 207 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
Chapter 6 Initial Configuration Tasks This chapter consists of the following sections: l Configuring System Parameters on page 56 l Changing Password on page 62 Configuring System Parameters This section describes how to configure the system parameters of a W-IAP. To configure system parameters: 1. Select System. Table 17: System Parameters Parameter Name Description Name of the W-IAP. CLI Configuration (Instant AP)# name System location Physical location of the W-IAP. (Instant AP)# (config)# syslocation Virtual Controller IP This parameter allows you to specify a single static IP address that can be used to manage a multi-WIAP Instant network. This IP address is automatically provisioned on a shadow interface on the W-IAP that takes the role of a VC. When a W-IAP becomes a VC, it sends three Address Resolution Protocol (ARP) messages with the static IP address and its MAC address to update the network ARP cache. (Instant AP)(config) # virtualcontroller-ip Allow IPv6 Management Select the check box to enable IPv6 configuration Virtual Controller IPv6 This parameter is used to configure the IPv6 address. (Instant AP)(config) # virtualcontroller-ipv6 Uplink switch native VLAN This parameter notifies the W-IAP about the nativeVLAN of the upstream switch to which the W-IAP is connected. The parameter stops the W-IAP from sending out tagged frames to clients connected with the SSID that has the same VLAN as the native VLAN of the upstream switch, to which the W-IAP is connected. By default, the W-IAP considers the uplink switch native VLAN value as 1. (Instant AP)(config) # enet-vlan Dell Networking W-Series Instant 6.5.1.0-4.3.1.0 | User Guide Initial Configuration Tasks | 56
![](/manual_guide/products/dell-wseries-207-instant-65104310-user-guide-c0193a6/56.png)