Dell W-Series 207 Instant 6.5.1.0-4.3.1.0 User Guide - Page 43
Graph, Description, Monitoring Procedure, Table 12
View all Dell W-Series 207 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
The following table describes the RF trends graphs available in the Client view: Table 12: Client View-RF Trends Graphs and Monitoring Procedures Graph Name Description Monitoring Procedure Signal The Signal graph shows the signal strength of the client for the last 15 minutes. It is measured in decibels. To see an enlarged view, click the graph. The enlarged view provides Last, Minimum, Maximum, and Average signal statistics of the client for the last 15 minutes. To see the exact signal strength at a particular time, move the cursor over the graph line. To monitor the signal strength of the selected client for the last 15 minutes: 1. Log in to the Instant UI. The Virtual Controller view is displayed. This is the default view. 2. On the Clients tab, click the IP address of the client for which you want to monitor the signal strength. 3. Study the Signal graph in the RF Trends pane. For example, the graph shows that signal strength for the client is 54.0 dB at 12:23 hours. Frames The Frames graph shows the In and Out frame rate per second of the client for the last 15 minutes. It also shows data for the Retry In and Retry Out frames. l Outgoing frames-Outgoing frame traffic is displayed in green. It is shown above the median line. l Incoming frames-Incoming frame traffic is displayed in blue. It is shown below the median line. l Retry Out-Retries for the outgoing frames are displayed above the median line in black . l Retry In-Retries for the incoming frames are displayed below the median line in red. To see an enlarged view, click the graph. The enlarged view provides Last, Minimum, Maximum, and Average statistics for the In, Out, Retries In, and Retries Out frames. To see the exact frames at a particular time, move the cursor over the graph line. To monitor the In and Out frame rate per second and retry frames for the In and Out traffic, for the last 15 minutes: 1. Log in to the Instant UI. The Virtual Controller view is displayed. This is the default view. 2. On the Clients tab, click the IP address of the client for which you want to monitor the frames. 3. Study the Frames graph in the RF Trends pane. For example, the graph shows 4.0 frames per second for the client at 12:27 hours. Speed The Speed graph shows the data transfer speed for the client. Data transfer is measured in Mbps. To see an enlarged view, click the graph. The enlarged view shows Last, Minimum, Maximum, and Average statistics of the client for the last 15 minutes. To monitor the speed for the client for the last 15 minutes: 1. Log in to the Instant UI. The Virtual Controller view is displayed. This is the default view. 2. On the Clients tab, click the IP address of the client for which you want to monitor the speed. 3. Study the Speed graph in the RF Trends pane. For example, the graph shows that the data transfer 43 | Instant User Interface Dell Networking W-Series Instant 6.5.1.0-4.3.1.0 | User Guide