Dell W-Series 207 Instant 6.5.1.0-4.3.1.0 User Guide - Page 57
Parameter, Description, CLI Configuration, Table 17
View all Dell W-Series 207 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
Table 17: System Parameters Parameter Dynamic Proxy NTP Server Description CLI Configuration This parameter allows you to enable or disable the dynamic proxy for RADIUS and Terminal Access Controller Access Control System (TACACS) servers. l Dynamic RADIUS proxy-When dynamic RADIUS proxy is enabled, the VC network will use the IP address of the VC for communication with external RADIUS servers. Ensure that you set the VC IP address as a Network Access Server (NAS) client in the RADIUS server if Dynamic RADIUS proxy is enabled. l Dynamic TACACS proxy-When enabled, the VC network will use the IP address of the VC for communication with external TACACS servers. The IP address is chosen based on one of the following rules: If a VPN tunnel exists between the W-IAP and the TACACS server, then the IP address of the tunnel interface will be used. If a VC IP address is configured, the the same will be used by the VC network to communicate with the external TACACS server. If a VC IP is not configured, then the IP address of the bridge interface is used. NOTE: When dynamic-tacacs-proxy is enabled on the W-IAP, the TACACS server cannot identify the slave W-IAP that generates the TACACS traffic as the source IP address is changed. To enable dynamic RADIUS proxy: (Instant AP)(config) # dynamic-radiusproxy To enable TACACS proxy: (Instant AP)(config) # dynamic-tacacsproxy This parameter allows you to configure NTP server. To facilitate communication between various elements in a network, time synchronization between the elements and across the network is critical. Time synchronization allows you to: l Trace and track security gaps, monitor network usage, and troubleshoot network issues. l Validate certificates. l Map an event on one network element to a corresponding event on another. l Maintain accurate time for billing services and similar tasks. To configure an NTP server: (Instant AP)(config) # ntp-server 57 | Initial Configuration Tasks Dell Networking W-Series Instant 6.5.1.0-4.3.1.0 | User Guide