Denon 4310CI Owners Manual - Page 62
Button, <button>, Button], <tuning, Preset>, <source, Select>
UPC - 883795001014
View all Denon 4310CI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 62 highlights
Tuning in Radio Stations - SIRIUS Satellite Radio Symbols used to indicate buttons in this manual Button located on both the main unit and the remote control unit Button only on the main unit Button only on the remote control unit BUTTON [BUTTON] ENTER AV< > [.ff.SAT TU] [TU A] [A - G] [TU 7] [MEMO] [SEARCH] AV ENTER [SOURCE SELECT] (MAIN mode) ..... ... [CHANNEL] [0 - 9]--4c- ) [SAT TU] I (MAIN mode) 1 [?DTU] [A - G] 71171 nl1 [TU A] I I [TU [MEMO] I [MODE] I [ABAvN [CHANNEL] [SOURCE SELECT] (MAIN mode) [1 - 8] [DTU] (MAIN mode) Checking the SIRIUS Signal Strength and Radio ID 1 Press until "SIGNAL" appears on the I display. The display will switch as shown below, depending on the reception conditions. Display Status i EXCELLENT Signal strength is excellent GOOD Signal strength is good WEAK Signal strength is weak NO SIGNAL No signal Adjust the position of the antenna until "SIGNAL: 2 EXCELLENT" is shown on the display. Press until the channel (example: "SR001") is displayed. 4 Press [TU or ETU 7] and select channel 0 (SR000). Channel No. and Sirius ID are alternately shown on the display. 55000 4 Sirius ID * Wr to your own SIRIUS ID for storage use. Sirius ID : The strength of both the SIRIUS satellite and terrestrial signals can be checked "Antenna Aiming" (1O- page 52). Presetting Radio Channels (Preset Memoryi Your favorite broadcast channels can be preset so that you can tune them in easily. Up to 56 channels can be preset. 1 Tune in the broadcast channel you want to preset. 2 Press [MEMO]. Press [A - G] to select the block in which the channel ' 11 is to be preset, then press [CHANNEL] or [1 - 8] to select the preset number. *The memory block can also be selected by pressing [SHIFT] on the sub-remote unit. 4 Press [MEMO] again to complete the setting. To preset other channels, repeat steps 1 to 4. NOTE Preset channels are erased by overwriting them. Listening to Preset Channels Press [CHANNEL] to select the desired preset channel, then press ENTER. * Selection is still possible if you press [1 - 8] after pressing [A - G]. You can also operate via the main unit. In this case, perform the following operations. Press , then turn to select the preset radio channel. [SHIFT] '(C) [DTU] [SAT TU] Sub remote control unit 59