Denon 4310CI Owners Manual - Page 97
AVR-4310C1's
UPC - 883795001014
View all Denon 4310CI manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 97 highlights
10.11.U00 GIOUJOH frog the Ma e Contr it Learning Function If your AV devices are of a brand other than DENON or if they canno be operated with the preset memory function, their remote control signals can be transfered to stored in the AVR-4310C1's main remote control unit. 1 Press and hold in [RC SETUP] for at least 3 seconds. The signal transmission indicator flashes twice. 2 Press [9], [7] and [5], in that order. The signal transmission indicator flashes twice and the learning mode is set. 3 Press [DEVICE SELECTOR] for the device you want to set 4 Press the button to be set. The main remote control unit's display turns off. If a button that cannot be learned is pressed, the signal transmission indicator lights but the signal is not learned. 5 Point the main remote control units directly at each other and press and hold the button on the other device's remote control unit that you want to learn. Once learning is completed normally, the display lights and the signal transmission indicator flashes twice. • With some remote control units, the signals cannot be learned or the device will not operate properly even when the signals have been learned. In this case, use the device's own remote control unit. • Learned buttons have priority over the preset memory. If you no longer need the learned setting, reset the learning function (Lepage 961. NOTE • [POWER ON], [POWER OFF] and [SOURCE SELECT] cannot be learned. • Do not learn any remote control signals at [RC SETUP]. • The MAIN, ZONE2, ZONE3, ZONE4 and MACRO modes cannot be learned. • Codes cannot be learned at [MASTER VOLUME] or [MUTE] when the main remote control unit is set to "TUNER", "SAT TU", "DTU", " NET/USE " or "iPod". MACRO Function This function lets you register a series of operations at a single button. For example, the amplifier can be turned on, the input source selected, the monitor's power turned on, the source device's power turned on and the play mode set all by pressing a single button. Up to 32 signals each can be registered at [MACRO] (1 - 31. Registering 1 Press and hold in [RC SETUP] for at least 3 seconds. The signal transmission indicator flashes twice. n Press [9], [7] and [8], in that order. L The signal transmission indicator flashes twice and the system call registration mode is set. 3 Press [MACRO] (1 - 3) at which you want to register the signals. 4 Press the buttons you want to register in the same sequence as the operations you want to perform. The signal transmission indicator lights when a button is pressed. Example : Press [POWER ON]. Press [DEVICE SELECTOR] - [DVD/HDP]. Press [110-]. The mode can be switched by pressing [DEVICE SELECTOR]. Perform the registration procedure for all the buttons you want to register. 5 Press and hold in [RC SETUP] for at least 3 seconds. The signal transmission indicator flashes twice and the setting is completed. If you want to learn other buttons, repeat steps 4 and 5. The mode can be switched by pressing [DEVICE SELECTOR]. The signal transmission indicator lights once for a long time if learning was not possible 6 Press and hold in [RC SETUP] for at least 3 seconds. The signal transmission indicator flashes twice and the setting is completed. Registration is not possible in ZONE2, ZONE3, ZONE4 and MACRO modes. 94