Denon 4310CI Owners Manual - Page 96

loaluo3 alowaH Operating the Main ' NET/USB EL Display 0.3 SAT 111 onono EL Display Device select button El NET/USB A- G TU IV MODE Preset memory block selection Switching picture Direct play (Rhapsody) SAT TU] : DTU] MEMO Buttons MENU/ SEARCH Preset memory registration Page Search / Character Search [„Rt.N[ERTi/pUoSdB]] 004 I> ENTER Cursor Enter SETUP/RSTR CH +/- RESTORER Preset channel selection 1- 8 Preset channel selection (1 -8) latal,g_10., 0 Buttons 93 CD C 7r .] f) Signal transmission indicator [DEVICE SELECTOR] [MI MAIN] Setting the Remote ID When using multiple DENON AV receivers in the same room, make this setting so that only the desired AV receiver operates. 1 Press [MAIN] to light the "MAIN" zone indicator. [POWER OFF] [POWER ON] [SOURCE SELECT] [MASTER VOLUME] [MUTE] [0 - 9] [RC SETUP] 2 Press and hold in [RC SETUP] for at least 3 seconds. The signal transmission indicator flashes twice. . . 3 Refer to the table at the right, and use [0 - 9] to input the 5-digit number corresponding to the remote ID to be changed. The signal transmission indicator flashes twice. 4 Press [SAT TU], [DTU], [iPod] or [NET/USB] to select the mode to be set. 5 Repeat steps 2 to 4 to set the remote IDs for all modes. Signal transmission indicator [DEVICE SELECTOR] ou MAIN lo) n -tr I [MACRO] DEVICE SELECTOR MAIN Remote ID 1 (Default) 2 3 4 81001 82001 83001 84001 SAT TU (SIRIUS, XM) 52415 52416 52417 52418 iPod 72815 72816 72817 72818 DTU NET/USB 62840 62841 62842 62843 62865 62837 62838 62839 NOTE • When changing a setting, be sure to set the same remote ID as the AVR-4310C1's )aZrpage 44). •When changing the MAIN mode's remote ID, also change the "SAT TU", "DTU" "iPod", and "NET/USB" remote ID at the same time. Cit___Z=15 C ) [0 - 9] [RC SETUP]