Dewalt DHS790AT2 Instruction Manual - Page 21
Accessories
View all Dewalt DHS790AT2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 21 highlights
English CLEANING THE DeWALT CORDED POWER SUPPLY WARNING: Never use solvents or other harsh chemicals for cleaning the non-metallic parts of the tool. These chemicals may weaken the plastic materials used in these parts. Use a cloth dampened only with water and mild soap. Never let any liquid get inside the tool; never immerse any part of the tool into a liquid. CLEANING THE CORDED POWER SUPPLY RECEPTACLE WARNING: Blow debris out of the corded power supply receptacle (BF) with clean, dry air. To minimize the risk of eye injury, always wear ANSI Z87.1 approved eye protection and respiratory protection when performing this. DUST DUCT CLEANING Depending on your cutting environment, saw dust can clog the dust duct and may prevent dust from flowing away from the cutting area properly. With the battery pack or corded power supply removed and the saw head raised fully, low pressure air or a large diameter dowel rod can be used to clear the dust out of the dust duct. CUTLINE™ LED WORKLIGHT CLEANING For the best worklight performance, perform the following maintenance regularly with the battery or corded power supply removed. • Carefully clean sawdust and debris from worklight lens with a cotton swab. • DO NOT use solvents of any kind, they may damage the lens. • Dust build-up can block the worklight and prevent it from accurately indicating the line of cut. • Follow miter saw's instruction manual to remove and install blade. • With blade removed from saw, clean pitch and build-up from blade. Pitch and debris can interfere with the worklight and prevent it from accurately indicating the line of cut. Accessories WARNING: Since accessories, other than those offered by DeWALT, have not been tested with this product, use of such accessories with this tool could be hazardous. To reduce the risk of injury, only DeWALT recommended accessories should be used with this product. Recommended accessories for use with your tool are available at extra cost from your local dealer or authorized service center. If you need assistance in locating any accessory, please contact DeWALT Industrial Tool Co., 701 East Joppa Road, Towson, MD 21286, call 1-800-4-DeWALT (1-800-433-9258) or visit our website: www.dewalt.com. OPTIONAL ACCESSORIES The following accessories, designed for your saw, may be helpful. In some cases, other locally obtained work supports, length stops, clamps, etc., may be more appropriate. Use care in selecting and using accessories. Extension Work Support: DW7080 Used to support long overhanging work pieces, the work support is user assembled. Your saw base is designed to accept two work supports, one on each side. LOCKNUTS END PLATE Adjustable Length Stop: DW7051 Requires the use of one Extension Work Support (DW7080). It is used to make repetitive cuts of the same length from 0 to 42" (107 cm). KNOBS Clamp: DW7082 (similar model included) Used for firmly clamping workpiece to the saw table for precision cutting. BRACKET Dust Bag: DW7053 (included with some models) Crown Molding Fence: DW7084 Equipped with a zipper for easy emptying, the dust bag will capture the majority of the sawdust produced. Used for precision cutting of crown molding. SAW BLADES: ALWAYS USE 12" (305 mm) SAW BLADES WITH EITHER 1" (25.4 mm) OR 5/8" (15.88 mm) ARBOR HOLES. SPEED RATING MUST BE AT LEAST 4800 RPM. Never use a smaller diameter blade. It will not be guarded properly. Use crosscut blades only! Do not use blades designed for ripping, combination blades or blades with hook angles in excess of 7°. 19