Epson ActionTower 7500 User Manual - Page 144
ption in for instructions on defining your new
![]() |
View all Epson ActionTower 7500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 144 highlights
5. Replace the bracket as shown below and secure it to the back panel with the four screws you removed earlier. 6. If there is a drive installed in the rear internal bracket, follow steps 6 through 8 under "Installing a Drive in the Rear Internal Bracket" to reconnect the drive and power cables to the drive. 7. If you have finished installing or removing drives, replace the computer's cover, as described under "Replacing the Cover" in Chapter 4. Then see "Using the Fixed Disk Setup 0ption" in Chapter 2 for instructions on defining your new drive configuration. Installing and Removing Tower Drives 6-23
![](/manual_guide/products/epson-actiontower-7500-user-manual-eb66eee/144.png)
5.
Replace the bracket as shown below and secure it to the
back panel with the four screws you removed earlier.
6.
If there is a drive installed in the rear internal bracket, follow
steps 6 through 8 under “Installing a Drive in the Rear
Internal Bracket” to reconnect the drive and power cables
to the drive.
7.
If you have finished installing or removing drives, replace
the computer’s cover, as described under “Replacing the
Cover” in Chapter 4. Then see “Using the Fixed Disk Setup
0ption” in Chapter 2 for instructions on defining your new
drive
configuration.
Installing and Removing Tower Drives
6-23