Epson C11C605001 Reference Guide - Page 41
Using multi-part forms, the Front Tractor on or Loading Paper Onto the Rear - dfx parts
UPC - 010343853614
View all Epson C11C605001 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 41 highlights
Using multi-part forms 2 You can use multi-part (carbonless or carbon-backed) forms with up to seven sheets, including the original, on the rear tractor. On the front tractor, you can use forms with up to ten sheets. You load continuous multi-part forms the same way you load any other type of continuous paper. Before loading multi-part 2 forms, however, make sure the paper has a clean straight edge 2 and does not separate or tear apart. See "Loading Paper Onto the Front Tractor" on page 15 or "Loading Paper Onto the Rear Tractor" on page 22 for instructions. The DFX-9000 can print on multi-part forms that vary in 2 thickness, such as forms with labels on them or forms that 2 overlap slightly where they are glued together. These forms are thicker in the label area and in the places where they overlap or are joined together, as shown below. Before you print on forms with labels, use SelecType to make sure the Forms w/labels 2 setting is set to On. When you use overlapping multi-part forms, set the Overlapping multipart forms setting to On and the Platen gap setting to 0 to 14, depending on the paper thickness you are using. See "Changing the settings in SelecType mode" on page 94 for details. 2 2 2 2 Overlapping multi-part forms Continuous forms with labels 2 Paper Handling 41