Epson C823622 Administrator's Manual - Page 174
Uninstalling EPSON Status Monitor 2, From Windows 95, 98, and NT 4.0
![]() |
View all Epson C823622 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 174 highlights
Uninstalling EPSON Status Monitor 2 You can remove EPSON Status Monitor 2 from your computer by following the instructions for your operating system below. c Caution: Quit other programs such as virus check programs before removing EPSON Status Monitor 2. Note for Windows 95: If EPSON TCP/IP printing is enabled, disable it as described on page 11-5. Note for Windows NT 3.51 and 4.0: u You need to log on as the Administrator. u When you try to uninstall EPSON Status Monitor 2 when using IntranetWare Client for NT in Windows NT 3.51/4.0, a message reading "Could not complete Setup because EPSON Status Monitor 2 is running. Quit EPSON Status Monitor 2 and run Setup again" may appear, and uninstall processing may terminate. In this case, delete the following files from the directory where EPSON Status Monitor 2 is installed, and then delete EPSON Status Monitor 2. Deleting these files will not cause errors in the operation of Novell IntranetWare Client for NT. Files: NETWIN16.DLL, CLNWIN16.DLL, LOCWIN16.DLL, NCPWIN16.DLL, NWIPXSPX.DLL, CLXWIN16.DLL, CALWIN16.DLL From Windows 95, 98, and NT 4.0 1. Close EPSON Status Monitor 2 as described in "Stopping Monitoring" on page 11-26. 11-28 EPSON Status Monitor 2 (Windows Only)
![](/manual_guide/products/epson-c823642-administrators-manual-1b40f45/174.png)