HP EliteDesk 705 G2 Maintenance and Service Guide - Page 50
Installing a secondary 3.5-inch hard drive, for an illustration
View all HP EliteDesk 705 G2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 50 highlights
Installing a secondary 3.5-inch hard drive 1. Prepare the computer for disassembly (Preparation for disassembly on page 19). 2. Remove the access panel (Access panel on page 20). 3. Install four silver 6-32 mounting screws on the sides of the drive (two on each side). NOTE: HP has supplied four extra silver 6-32 mounting screws installed on the chassis next to the primary 3.5-inch hard drive bay. Refer to Installing and Removing Drives on page 32 for an illustration of the location of the extra mounting screws. When replacing a drive, transfer the four mounting screws from the old drive to the new drive. 4. Rotate the drive cage to its upright position. 40 Chapter 4 Removal and replacement procedures - small form factor (SFF) chassis
Installing a secondary 3.5-inch hard drive
1.
Prepare the computer for disassembly (
Preparation for disassembly
on page
19
).
2.
Remove the access panel (
Access panel
on page
20
).
3.
Install four silver 6-32 mounting screws on the sides of the drive (two on each side).
NOTE:
HP has supplied four extra silver 6-32 mounting screws installed on the chassis next to the
primary 3.5-inch hard drive bay. Refer to
Installing and Removing Drives
on page
32
for an illustration of
the location of the extra mounting screws.
When replacing a drive, transfer the four mounting screws from the old drive to the new drive.
4.
Rotate the drive cage to its upright position.
40
Chapter 4
Removal and replacement procedures – small form factor (SFF) chassis