HP EliteDesk 705 G2 Maintenance and Service Guide - Page 56
Drive power cable
View all HP EliteDesk 705 G2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
Drive power cable 1. Prepare the computer for disassembly (Preparation for disassembly on page 19). 2. Remove the access panel (Access panel on page 20). 3. Rotate the drive cage to its upright position. 4. Disconnect the cable from the system board connector labeled SATAPWR0. 5. Disconnect the cable from the hard drive and the optical drive. 6. Remove the cable from the clips on the base pan and on the drive cage, and then remove the drive power cable from the computer. To reinstall the drive power cable, reverse the removal procedure. 46 Chapter 4 Removal and replacement procedures - small form factor (SFF) chassis
Drive power cable
1.
Prepare the computer for disassembly (
Preparation for disassembly
on page
19
).
2.
Remove the access panel (
Access panel
on page
20
).
3.
Rotate the drive cage to its upright position.
4.
Disconnect the cable from the system board connector labeled SATAPWR0.
5.
Disconnect the cable from the hard drive and the optical drive.
6.
Remove the cable from the clips on the base pan and on the drive cage, and then remove the drive
power cable from the computer.
To reinstall the drive power cable, reverse the removal procedure.
46
Chapter 4
Removal and replacement procedures – small form factor (SFF) chassis