HP EliteOne 800 Maintenance & Service Guide HP EliteOne 800 G1 All-in-One - Page 111
Caution
View all HP EliteOne 800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 111 highlights
14. If disassembling a non-touch model, the display panel cable is connected to the bottom of the panel. After lifting the panel up from the bezel, look underneath to see the connected display panel cable. Lift the cable from the bottom of the panel to disengage it from the adhesive that secures it to the panel, and then disconnect the display cable from the display panel by pressing in on the tabs (1) on the side of the connector, and then pulling the cable from the connector (2). To install the front bezel, reverse the removal procedures. Be sure to correctly position the jumpers on the converter board for the installed display panel. The jumper settings are shown on a label near the converter board. CAUTION: Incorrect jumper placement can result in damage to the converter board and display panel. Front bezel and display panel 101