HP EliteOne 800 Maintenance & Service Guide HP EliteOne 800 G1 All-in-One - Page 113
Hard drive and optical drive cables and connectors, Remove the power supply see
View all HP EliteOne 800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 113 highlights
Hard drive and optical drive cables and connectors Description Optical drive cable (data and power assembly) Hard drive cable (data and power assembly) Spare part number 733492-001 733491-001 The hard drive and optical drive connectors are located near the middle of the computer, partially under the main frame. Each connector is secured with two Torx screws and has two cables that connect to the system board. To remove the hard drive or optical drive connector: 1. Prepare the computer for disassembly (see Preparing to disassemble the computer on page 35). 2. Remove the stand (see Stand on page 37). 3. Remove the access panel (see Access panel on page 41). 4. Remove the lower rear panel (see Lower rear panel on page 74). 5. Remove the side panels (see Side panels on page 92). 6. Remove the VESA mounting plate (see VESA mounting plate on page 84). 7. Remove the power supply (see Power supply on page 86). 8. Remove the system board (see System board on page 88). 9. Remove the front bezel and display panel (see Front bezel and display panel on page 97). 10. Remove two Torx screws that secure the hard drive connector or the optical drive connector to the computer. 11. Remove the cables from the metal clips built into the computer. 12. Disconnect the hard drive cables or the optical drive cables from the system board. NOTE: Be careful not to damage the cable when disconnecting it from the board. Do not pull on the wires. Hard drive and optical drive cables and connectors 103