HP EliteOne 800 Maintenance & Service Guide HP EliteOne 800 G1 All-in-One - Page 90
Converter board, Disconnect the two cables from the board
View all HP EliteOne 800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 90 highlights
Converter board Description Converter board Spare part number 732493-001 The converter board is located on the left side of the computer (viewed from behind) under the main rear cover. It is secured with two Torx screws and has two connectors. Use the same converter spare part for all display panels; however, you must change jumper settings on the board based on the display panel. To remove the converter board: 1. Prepare the computer for disassembly (see Preparing to disassemble the computer on page 35). 2. Remove the stand (see Stand on page 37). 3. Remove the access panel (see Access panel on page 41). 4. Remove the lower access panel (see Lower rear panel on page 74). 5. Disconnect the two cables from the board (1). NOTE: Be careful not to damage the cables when disconnecting them from the board. Do not pull on the wires. 80 Chapter 5 Removal and Replacement Procedures All-in One (AIO) Chassis