HP EliteOne 800 Maintenance & Service Guide HP EliteOne 800 G1 All-in-One - Page 55
The primary drive is the lower position in the drive cage. If only one drive is to be, installed
View all HP EliteOne 800 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 55 highlights
3. Pull the latch next to the lower side of the 2.5-inch hard disc drive cage away from the cage to release it, then slide the cage toward the edge of the chassis and lift it out. 4. If there is a second disc drive in the 2.5-inch cage, disconnect both cables from it. 5. Remove the four mounting screws from each 2.5-inch hard disc drive to be removed. Be sure to keep the screws together with the blue rubber grommets to use to install a replacement drive. NOTE: The primary drive is the lower position in the drive cage. If only one drive is to be installed, it must occupy this position. 6. Remove the 2.5-inch hard disc drive(s) from the cage. For instructions on installing a hard disc drive, see Installing a 2.5-inch hard disc drive on page 46. Drives 45