HP Indigo 10000 HD Writing Head Service Document - Page 32
until the damper's screw is rotating freely and move damper to its most upper position
View all HP Indigo 10000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 32 highlights
11. Remove the alignment pins from the front and rear mounts and store them in the slots next to the Spitz crane mount. 12. Tighten the 3 mounting bracket screws by hand force only. a. Check that damper's screw is rotating freely without applying force. If not - lift up the WH until the damper's screw is rotating freely and move damper to its most upper position by unscrewing its screw. b. Move down dampers by closing their screws by hand force only until the dampers touch spring's base (the moment you feel it's no longer possible to rotate the damper's screw freely). 30 Chapter 2 Procedures
11.
Remove the alignment pins from the front and rear mounts and store them in the slots next to the
Spitz crane mount.
12.
Tighten the 3 mounting bracket screws by
hand force only
.
a.
Check that damper’s screw is rotating freely without applying force. If not – lift up the WH
until the damper’s screw is rotating freely and move damper to its most upper position by
unscrewing its screw.
b.
Move down dampers by closing their screws by hand force only until the dampers touch
spring’s base (the moment you feel it’s no longer possible to rotate the damper’s screw freely).
30
Chapter 2
Procedures