HP Indigo 10000 HD Writing Head Service Document - Page 72
Installing the feeder side damper
View all HP Indigo 10000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 72 highlights
5. Install the middle 4 screws as shown below - Do not tighten. 6. When all 8 screws are aligned keep lowering down the WH by turning the knob counter-clockwise until the two metal brackets are in full contact. Turn the knob another 4-5 turns in the same direction. 7. Tighten the 8 screws installed in Steps 3 and 5. Installing the feeder side damper Follow these steps to install the feeder side damper. 1. If the brackets are not properly aligned, open the nut at the unit upper side. 70 Appendix B Appendix B - Installing the motorized interface shipment dampers
5.
Install the middle 4 screws as shown below - Do not tighten.
6.
When all 8 screws are aligned keep lowering down the WH by turning the knob counter-clockwise
until the two metal brackets are in full contact. Turn the knob another 4-5 turns in the same
direction.
7.
Tighten the 8 screws installed in Steps 3 and 5.
Installing the feeder side damper
Follow these steps to install the feeder side damper.
1.
If the brackets are not properly aligned, open the nut at the unit upper side.
70
Appendix B
Appendix B - Installing the motorized interface shipment dampers