HP Indigo 10000 HD Writing Head Service Document - Page 70
Rotate each screw just a few threads inside - do not tighten
![]() |
View all HP Indigo 10000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 70 highlights
1. Raise up the WH (by turning the motors knob clockwise) until you can insert the front / rear damper in place. 2. Note the damper orientation. The damper small handle bar should be pointing downwards. 3. Install the 4 screws inside the slots as shown below. NOTE: Rotate each screw just a few threads inside - do not tighten. 68 Appendix B Appendix B - Installing the motorized interface shipment dampers
![](/manual_guide/products/hewlettpackard-indigo-10000-hd-writing-head-service-document-089677d/70.png)
1.
Raise up the WH (by turning the motors knob
clockwise
) until you can insert the front / rear damper
in place.
2.
Note the damper orientation. The damper small handle bar should be pointing downwards.
3.
Install the 4 screws inside the slots as shown below.
NOTE:
Rotate each screw just a few threads inside - do not tighten.
68
Appendix B
Appendix B - Installing the motorized interface shipment dampers