HP LH4r HP Netserver LH 3/3r User Guide - Page 26
Help topic Tested Parts List on the HP NetServer Navigator
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Chapter 4 Installing Accessory Boards • The ISA Board Slot, which accepts a single ISA board. This slot is shared with PCI slot 1. Either slot can be occupied, but not both. • The two SCSI connectors, A and B, which are separate channels that control the disk arrays in the right (standard) and left (optional) hot-swap mass storage cages, respectively. The base configuration of the NetServer has one hot-swap mass storage cage on the right side, controlled by a connection to SCSI connector A. By default, this disk array is controlled by the integrated HP NetRAID controller. Remote Management I/0 Memory SE SCSI PCI Board Slots ISA Board Slot SCSI B SCSI A Figure 4-2. I/O Board With Devices and Bus Structure NOTE For a list of boards HP has tested with the NetServer, see the Help topic "Tested Parts List" on the HP NetServer Navigator CD-ROM. Installing Accessory Boards Remove the NetServer's cover: (See Chapter 3, "Removing and Replacing Covers.") To install accessory boards: 1. Read the documentation included with each accessory board. Follow any special instructions and installation recommendations. Some boards have 18