HP LH4r HP Netserver LH 3000/3000r to LH 6000/6000r Upgrade Guide - Page 15

Removing Components from the, LH 3000/3000r

Get HP LH4r - NetServer - 256 MB RAM PDF manuals and user guides View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals

Page 15 highlights

3 Removing Components from the LH 3000/3000r Removing components from the HP NetServer LH 3000/3000r has these steps: l Power off the NetServer. l Remove covers and system board. l Remove chassis guide and air baffles. WARNING Do not proceed with this upgrade without first purchasing the appropriate Power Supply Upgrade Kit. The HP NetServer LH 6000/6000r cannot operate without a minimum of three power supplies. Power off the NetServer If you have not done so already, power off the NetServer as follows: 1. Close all applications, log off all users, and gracefully shut down the network operating system according to directions in your NOS documentation. 2. Press the power switch on the HP NetServer's control panel when prompted by the operating system. 3. Disconnect all power and telephone cords. WARNING Power supplies will continue to provide standby current to the NetServer until the power cords are disconnected. 11

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
11
3
Removing Components from the
LH 3000/3000r
Removing components from the HP NetServer LH 3000/3000r has these steps:
Power off the NetServer.
Remove covers and system board.
Remove chassis guide and air baffles.
WARNING
Do
not
proceed with this upgrade without first purchasing the
appropriate Power Supply Upgrade Kit. The HP NetServer
LH 6000/6000r cannot operate without a minimum of three
power supplies.
Power off the NetServer
If you have not done so already, power off the NetServer as follows:
1.
Close all applications, log off all users, and gracefully shut down the
network operating system according to directions in your NOS
documentation.
2.
Press the power switch on the HP NetServer’s control panel when
prompted by the operating system.
3.
Disconnect all power and telephone cords.
WARNING
Power supplies will continue to provide standby current to the
NetServer until the power cords are disconnected.