HP LH4r HP Netserver LH 3000/3000r to LH 6000/6000r Upgrade Guide - Page 30
Technical Reference Card
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
Chapter 4 Installing LH 6000/6000r Components Figure 4-8. Install Additional VRMs if You Have Installed More Than Two Processor Modules a. Identify the VRM socket(s) where you must install VRMs. Two VRMs have been preinstalled. All VRMs must be installed in ascending slot order as indicated in Figure 4-5. b. Open the VRM retaining latch. c. Orient the VRM as shown in Figure 4-8 and press the VRM into the socket until it is seated completely. The retaining latches close automatically when the VRM is installed correctly. CAUTION When installing the new VRM, push only on the edge of the main VRM board. Do not push on the large flat surface (if your VRM has one) or any components on the board. Pushing on any part of the VRM except the edge of the main board may result in damage to the VRM. d. Verify that the VRM is installed completely in the socket and the retaining latches at the ends of the sockets are closed. 9. Check that your configuration switches are set correctly for your processors. See the Technical Reference Card for the HP NetServer LH 6000/6000r. 26