HP LH4r HP Netserver LXr Pro8 User Guide - Page 27
Redocking the Satellite Chassis
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Chapter 3 Ejector Handles Opening and Closing the HP NetServer Figure 3-3. Sliding Out the Satellite Chassis Redocking the Satellite Chassis 1. When you finish servicing the HP NetServer, move to the front of the server and unlatch all four power supplies. (If the front bezel is in place, remove it. See "Removing and Replacing the Front Bezel." 2. At the rear, insert the satellite chassis. To do so, push in the release latch for each slide (Figure 3-4). While holding the latches down, push the satellite part-way onto the base, so that the latches can no longer engage. 19
Chapter 3
Opening and Closing the
HP NetServer
19
Ejector Handles
Figure 3-3. Sliding Out the Satellite Chassis
Redocking the Satellite Chassis
1.
When you finish servicing the HP NetServer, move to the front of the
server and unlatch all four power supplies. (If the front bezel is in place,
remove it. See "Removing and Replacing the Front Bezel."
2.
At the rear, insert the satellite chassis. To do so, push in the release latch
for each slide (Figure 3-4). While holding the latches down, push the
satellite part-way onto the base, so that the latches can no longer engage.