HP LH4r HP Netserver LXr Pro8 User Guide - Page 3

Contents 1 Setting Up the HP NetServer LXr Pro8 1 Before You Set Up Your HP NetServer 1 Setup Steps 1 2 Controls, Indicators, and Ports 5 Front Panel Controls 5 Power Supply Indicators 7 Rear Panel Controls, Ports, and Indicators 8 Power-Up and Power-Down Procedures 10 Power-Up Procedure 10 Power Down Procedure 11 Connecting AC Power to Multiple-Server Configurations 12 3 Opening and Closing the HP NetServer 15 Multiple Points of Access 15 Removing and Replacing the Front Bezel 15 Undocking the Satellite Chassis 16 Redocking the Satellite Chassis 19 Detaching and Reattaching the Satellite Chassis 21 Opening or Removing the Satellite Chassis' Top Cover 24 Accessing the Lower Board Cage 27 4 Installing Mass Storage 29 Types of Devices That Can Be Installed 29 Boot Device Priority 29 Setting the Device's SCSI Device ID 30 Installing an Internal Hard Disk Drive 30 Installing the First or Second Drive in the Server 30 Installing Hard Drives in all Three Bays 32 5 Installing Additional Memory 35 Introduction 35 Installation Basics 35 Tools Required 38 Removing the Memory Board 38 Installing 128 MB SDRAM DIMMs on the 4 GB Memory Board 40 iii