HP LH4r HP Netserver LXr Pro8 User Guide - Page 63
Update, Return Kit
View all HP LH4r manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 63 highlights
Chapter 6 Installing Additional Boards 11. You may return the terminator boards you removed to Hewlett-Packard for environmentally safe disposal. To return used boards, see the Update Return Kit. NOTE If you ever choose to remove one of the processor boards and run the HP NetServer with fewer processors, note that you must have a terminator board on hand to put in place of the processor board. 12. Remove the processor board from the sealed bag. NOTE Do not change the jumper settings on the processor board. These settings are factory set. 13. Install the processor board in the slot from which you removed the terminator board. Gently, but firmly, push the board into place. You must install one processor board for every terminator board that you removed. 14. Using a Phillips head screwdriver, secure the mounting screws in place. NOTE You are not required to use the HP Navigator CD-ROM to reconfigure your system after installing the new processor board. The system detects the additional processors automatically. However, we recommend that you use the HP Navigator CD-ROM to ensure that you have the latest drivers and information. 15. Replace the cover of the satellite chassis. See Chapter 3. 16. Reattach the satellite chassis to the base chassis. See Chapter 3 for details. 17. Reconnect any cables to PCI cards you might have disconnected earlier. Reconnect the AC power cord if you disconnected it earlier. 18. Lock the power interlock switch by turning it counterclockwise. See Chapter 2. 55