HP Scanjet 5000 User Guide - Page 68
GPU enablement kit
View all HP Scanjet 5000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 68 highlights
12. Connect each power cord to the power source. 13. Power up the server (see Powering up the server on page 16). GPU enablement kit WARNING! To reduce the risk of personal injury, electric shock, or damage to the equipment, remove the power cord to remove power from the server. The front panel Power On/Standby button does not completely shut off system power. Portions of the power supply and some internal circuitry remain active until AC power is removed. CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all PCI slots have either an expansion slot cover or an expansion board installed. To install the component: 1. Power down the server (see Powering down the server on page 16). 2. Remove all power: a. Disconnect each power cord from the power source. b. Disconnect each power cord from the server. 3. Do one of the following: ● Extend the server from the rack (see Extending the server from the rack on page 17). ● Remove the server from the rack (see Removing the server from the rack on page 17). 4. Remove the access panel (see Removing the access panel on page 18). 5. Remove the air baffle (see Removing the air baffle on page 25). 6. Remove the standard efficiency air diverters from the air baffle. 60 Chapter 5 Hardware options installation