HP TouchSmart IQ506t Watching and Recording TV - Page 14

Troubleshooting the Remote Control

Get HP TouchSmart IQ506t PDF manuals and user guides View all HP TouchSmart IQ506t manuals
Add to My Manuals
Save this manual to your list of manuals

Page 14 highlights

Troubleshooting the Remote Control If the remote control doesn't work: Make sure that the batteries for the remote control are charged and installed correctly. Make sure the front of the remote sensor (IR receiver) is not blocked. If a pressed key repeats itself or sticks, try altering the lighting conditions in the room if this continues. Press the Enter button on the remote control after changing a channel. Point the remote control toward the remote sensor, and press a button. A faint red light should appear on the remote sensor. If the light appears, then the problem is probably in the Windows Media Center software. Close Windows Media Center, restart the computer, and then open Windows Media Center again. If the remote control works in Windows Media Center but not when changing channels, you need to reconfigure the Windows Media Center software settings for the cable set-top box or satellite receiver. 10 Watching and Recording TV

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
10
Watching and Recording TV
Troubleshooting the Remote Control
If the remote control doesn’t work:
±
Make sure that the batteries for the remote control are charged and installed correctly.
±
Make sure the front of the remote sensor (IR receiver) is not blocked.
±
If a pressed key repeats itself or sticks, try altering the lighting conditions in the room if
this continues.
±
Press the Enter button on the remote control after changing a channel.
±
Point the remote control toward the remote sensor, and press a button. A faint red light
should appear on the remote sensor. If the light appears, then the problem is probably
in the Windows Media Center software. Close Windows Media Center, restart the
computer, and then open Windows Media Center again.
If the remote control works in Windows Media Center but not when changing channels,
you need to reconfigure the Windows Media Center software settings for the cable set-top
box or satellite receiver.