HP Visualize b180L installing the hp Visualize workstation b132L/b160L to b180 - Page 16

Installing Additional Memory Modules on the New Main Tray Assembly Installing Additional Memory Modules on the New Main Tray Assembly Take a moment to read over the following important notes about installing memory. • Before you attempt to install additional memory modules in your B180L work- station, check the memory configuration information you recorded in step 4 of "Prepare your Workstation". • Read over the steps involved in installing memory modules before you begin. • You must insert memory modules in pairs of equal size. • Modules should be inserted in the lowest numbered memory pair first then in numerical order. For example, install memory in 0A and 0B first, then 1A and 1B, and 2A and 2B. Refer to Figure 6 for memory pair numbering and location. You must also install the largest memory modules first. For example, if you have a 64 MByte memory pair, a 32 Mbyte pair, and a 16 MByte memory pair, install the 64 MByte memory pair in slots 0A and 0B. Then install the 32 MByte memory pair in slots 1A and 1B, and the 16 MByte pair in slots 2A and 2B. • When you have finished installing additional memory modules, use the Boot Console Interface to verify that they are seen by the workstation. 14