HP Workstation xw6000 Adaptec SCSI RAID 2120S: Software User's Guide - Page 27
Using the Controller Configuration Utility
View all HP Workstation xw6000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Using Adaptec RAID Configuration Using the Controller Configuration Utility To access the Controller Configuration Utility: 1 When you turn on or reboot your system, press Ctrl+A to access ARC when prompted by the following message: Press for Adaptec RAID Configuration Utility 2 If multiple controllers are installed, select the controller you want to configure and press Enter. 3 From the ARC menu, select SCSISelect Utility. The Controller Configuration and SCSI Configuration menu options are displayed. 4 Select Controller Configuration. You can modify the following Controller Interface Definitions: ■ Drives Write Cache - Enables or disables the write-back cache feature of all SCSI disk drives connected to the controller. If Disabled, the controller will disable the writeback cache of all attached drives. If Enabled, then the controller will enable the write-back cache of all attached drives. If Drive Default, then the controller will not change the write-back cache setting of any attached drives. The default is Drive Default. ! Caution: Disk drives with write-back cache enabled do not have the benefit of battery protection and could lose or corrupt data as a result of unexpected power loss or drive removal. Certain controllers may not support drives write cache. In those cases where drives write cache is not supported, setting the option to Enabled has no effect. ■ Runtime BIOS - Enables or disables the controller's runtime BIOS. The BIOS must be enabled if you want to boot from the controller. 2-11