HP bc1000 Setup & Installation Guide - Page 39
Screw the hexagonal washer onto the shaft of the screw until
View all HP bc1000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 39 highlights
Installing and Cabling the HP CCI Solution 4. Place the hexagonal washer at the back of the hole in the enclosure 1. 5. Insert the screw through the hole in the enclosure. 6. Press the head of the screw inward so that the spring is completely compressed 2. 7. Screw the hexagonal washer onto the shaft of the screw until it passes all the threads and is secure within the thumbscrew housing 3. Replacing a thumbscrew, spring, and hexagonal washer 8. Repeat steps 1 through 7 for the other thumbscrew. Å WARNING: Remove the two hot-plug power supplies before installing the enclosure into the rack to reduce weight. Å WARNING: At least two people must lift the enclosure into the rack together. If the enclosure is loaded into the rack above chest level, a third person must assist with aligning the enclosure with the rails while the other two people support the weight of the enclosure. Ä CAUTION: Do not remove the enclosure from the rack by the thumbscrews. Use the handles located above the thumbscrews. Setup and Installation Guide www.hp.com 4-11