IBM 8478 Hardware Maintenance Manual - Page 106
Handle, assembly, Adapter, retainer
![]() |
UPC - 087944650553
View all IBM 8478 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 106 highlights
6. Remove the four screws from the back of the server and put them in a safe place. 7. Using a screwdriver, gently pry the cover away from the server in the rear and slide the unit away from the server. Handle assembly Before you begin: v Read "Safety information" on page 125. v Review the information in "Before you begin" on page 44. To remove the handle cap, do the following: 1. Power-off the server, if it is on. 2. Unplug the server. 3. Use a flathead screwdriver to gently press in and down on the tabs located on the interior side wall of the handle. 4. Lift up on the handle cap to separate it from the handle support. To remove the handle support, do the following: 1. Power-off the server, if it is on. 2. Unplug the server. 3. Firmly grasp the handle support and slide it away from the front bezel. 4. Lift up on the handle support to remove it from the slots in the top of the chassis. Adapter retainer Before you begin: v Read "Safety information" on page 125. v Review the information in "Before you begin" on page 44. 96 Hardware Maintenance Manual: xSeries 200
![](/manual_guide/products/ibm-8478-hardware-maintenance-manual-4ca71d5/106.png)