IBM 8478 Hardware Maintenance Manual - Page 77
microprocessor
![]() |
UPC - 087944650553
View all IBM 8478 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 77 highlights
Microprocessor connector Microprocessor Lever Microprocessor orientation indicator Note: Do not use excessive force when pressing the microprocessor into the connector. 5. Push the microprocessor release lever down to lock the microprocessor into the connector. 6. Install a heat sink or fan sink. v If you are installing a heat sink on the microprocessor: Note: Refer to the illustration in "Removing a microprocessor" on page 65. a. Peel the plastic protective strip off the bottom of the heat sink. Make sure the square of thermal material is still on the bottom of the heat sink; if not, replace the it with a new heat sink. b. Align and place the heat sink on top of the microprocessor. c. Align and place the heat sink retainer over the heat sink, then snap it into place. v If you are installing a fan sink on the microprocessor: Chapter 5. Installing options 67
![](/manual_guide/products/ibm-8478-hardware-maintenance-manual-4ca71d5/77.png)