IBM 8478 Hardware Maintenance Manual - Page 59
Removing, support, bracket, assembly
![]() |
UPC - 087944650553
View all IBM 8478 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 59 highlights
Removing the support bracket assembly When working with some options such as hard disk drives, microprocessors, and memory modules you must first remove the support bracket assembly to access the location of the option. Complete the following steps to remove the support bracket assembly: 1. Review the information in "Before you begin" on page 44. 2. Turn off the server and peripheral devices and disconnect all external cables and power cords. 3. Disconnect the support bracket assembly fan cable from the connector (SYSFA3) on the system board. For the location of the fan connector, see "System board internal cable connectors" on page 42. 4. Pull out, about 152.4 mm (6 in.), on the end of the support bracket assembly located at the rear of the server. 5. Pull the front end of the support bracket assembly away from the server and place the assembly aside. Chapter 5. Installing options 49
![](/manual_guide/products/ibm-8478-hardware-maintenance-manual-4ca71d5/59.png)