IBM 8478 Hardware Maintenance Manual - Page 69
Installing, drive
UPC - 087944650553
View all IBM 8478 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 69 highlights
Note: Make sure to route the signal cable so that it does not block the air flow to the rear of the drives or over the microprocessor. 9. If you have other options to install or remove, do so now. 10. Connect one of the power cables from the power supply into the back of the drive. The connectors are keyed and can be inserted only one way. 11. Replace the support bracket assembly and reconnect the fan cable to the connector (SYSFA3) on the system board. See "System board internal cable connectors" on page 42 for the location of the fan cable connector. 12. Reinstall the side cover, see "Installing the cover" on page 70 for details. 13. Reconnect the external cables and power cords; then, turn on the peripheral devices and the server. Installing a hard disk drive in bay 5, 6, or 7 Drive cage retention tab Drive cage release tab Complete the following steps to install a hard disk drive in bay 5, 6, or 7. Chapter 5. Installing options 59