IBM 8478 Hardware Maintenance Manual - Page 78
instructions
![]() |
UPC - 087944650553
View all IBM 8478 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 78 highlights
Microprocessor connector Microprocessor Fan sink Fan sink connector Lever Fan-sink retainer Microprocessor orientation indicator a. Peel the plastic protective strip off the bottom of the fan sink. Make sure the square of thermal material is still on the bottom of the fan sink; if not, replace the it with a new fan sink. b. Align and place the fan sink on top of the microprocessor. c. Align and push the fan-sink retainer through the groove in the center of the fan sink. d. Insert a small, flat-bladed screwdriver into the tab on the fan-sink retainer. e. Press the screwdriver down to snap the fan-sink retainer into place. f. Connect the fan-sink power cable to the microprocessor fan-sink connector (CPUFA1) on the system board. See "System board internal cable connectors" on page 42 for the location of the microprocessor fan-sink connector. 7. If you have other options to install or remove, do so now; otherwise, replace the support bracket assembly. See "Removing the support bracket assembly" on page 49 for details. See "System board internal cable connectors" on page 42 for the location of the fan cable connector. See "Installing the cover" on page 70 for instructions on installing the cover. 8. Reconnect the external cables and power cords; then, turn on the peripheral devices and the server. 68 Hardware Maintenance Manual: xSeries 200
![](/manual_guide/products/ibm-8478-hardware-maintenance-manual-4ca71d5/78.png)