Icom IC-7610 Instruction Manual basic - Page 49

7 ANTENNA TUNER OPERATION About the Antenna memory settings This function saves antenna connector settings for each frequency band. You can set antenna connectors ANT1, ANT2, ANT1/R, ANT2/R, ANT1 or ANT2 to selected bands. LANT1 is set to all frequency bands as the default. DDThe Antenna memory screen The Antenna memories are set on the ANTENNA screen. MENU » ANTENNA Antenna selection mode Antenna type setting DDSaving an antenna connector setting Example: Assigning ANT2 to the 10 MHz band. 1. Display the ANTENNA screen. MENU » ANTENNA 2. Select the 10 MHz band. Displayed while a different antenna The Temporary function from the original is temporarily selected. (Example: ANT 2) memory ON or OFF. An example of antenna connector settings for each frequency band. Key ANT RX-ANT Action Selects [ANT1] or [ANT2 is displayed if you temporarily select an antenna that is different from the one that is saved in the memory. Selects [ANT1/R] or [ANT2/R]. ••This key is displayed when TYPE is set to "RX-ANT." (See "Selecting the antenna type" on page 7-2) Selects [ANT1 ] or [ANT2 ]. RX/I/O ••This key is displayed when TYPE is set to "RX-I/O." (See "Selecting the antenna type" on page 7-2) Recalls the originally saved antenna setting in ANT MR the memory. ••This key can be used when [[ANT] SW] is set to "Auto." ANT MW Touch for 1 second Saves the current antenna connector setting in the antenna memory. Turns the Temporary memory function ON or TEMP-M OFF. ••This function temporarily memorizes the antenna that is manually selected. Selects the Antenna selection mode from "Auto," "Manual" and "OFF." [ANT] SW ••Auto: Uses the Antenna memory. ••Manual: Selects each antenna connector according to the saved settings. ••OFF: [ANT1] is fixed. TYPE Selects the antenna type to "RX-ANT" or "RX-I/O." TIP: When [[ANT] SW] is set to "OFF" or when in the Transverter operation, the [ANT], [RX-ANT] and [RX-I/O] keys cannot be used. 3. Touch [ANT] and select "2 (ANT2)." "2 " is displayed. "2 " is displayed. LYou can recall the originally saved antenna setting (Example: ANT1), touch [ANT MR]. 4. Touch [ANT MW] for 1 second to save "2 (ANT2)" to the 10 MHz band disappears. 5. To close the ANTENNA screen after saving, push EXIT . NOTE: Before transmitting with a selected antenna, be sure that the selected antenna suits the operating frequency by using the antenna tuner (p. 7-3). Otherwise the transceiver may be damaged. 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 7-1