Icom IC-7610 Instruction Manual basic - Page 55

SET MODE 8 Beep Sound (MAIN) Beep Sound (SUB) (Default: 1000Hz) (Default: 1000Hz) Set the audio frequency for beeps. RF/SQL Control (Default: RF+SQL) Set the AF RF/SQL (outer) control operation. MENU » SET > Function > TX Delay HF 50M (Default: OFF) (Default: OFF) Sets the TX delay time on the HF or 50 MHz band. LIf an external equipment's rise time is slower than that of the IC-7610, a reflected wave is produced and it may damage the IC-7610 or the external device. To prevent this, set the appropriate delay time so that no reflected wave, or timing damage occurs. LSelect "OFF" for no rise speed. SEND Rx Tx Po 0 10 Delay time (ms) MENU » SET > Function Time-Out Timer (CI-V) (Default: OFF) Sets the Time-out Timer for CI-V operation. This setting is valid only transmitting initiated by a CI-V command or pushing TRANSMIT . LSelect "OFF" for no time limit. Quick Dualwatch (Default: ON) Turns the Quick Dualwatch function ON or OFF by holding down DUAL-W for 1 second. MENU » SET > Function > SPLIT Quick SPLIT (Default: ON) Turns the Quick Split function ON or OFF by holding down SPLIT for 1 second. FM SPLIT Offset (HF) FM SPLIT Offset (50M) (Default: -0.100 MHz) (Default: -0.500 MHz) Sets the frequency offset for the Split function in the FM mode on the HF or 50 MHz band. SPLIT LOCK (Default: OFF) Turns the Split Lock function ON or OFF. MENU » SET > Function > Tuner PTT Start (Default: OFF) Turns the PTT Start Tuning function ON or OFF. 1 This function starts tuning when [PTT] is pushed, if the operating frequency is shifted while the antenna tuner is ON. 2  3 Clears all of the internal antenna tuner's entered memory frequencies. 4 MENU » SET > Function 5 Transverter Function 6 (Default: Auto) Selects whether to turn ON the transverter function or to automatically turn it ON when 2 to 13.8 V DC is 7 applied to pin 6 of [ACC 2]. 8 Transverter Offset (Default: 16.000 MHz) Sets the offset frequency for transverter operation. 9 RTTY Mark Frequency 10 (Default: 2125) Selects the RTTY mark frequency. LWhen the internal RTTY decoder is used, 2125 Hz 11 is automatically selected. 12 RTTY Shift Width Selects the RTTY shift width. 13 (Default: 170) LWhen the internal RTTY decoder is used, 170 Hz is automatically selected. 14 RTTY Keying Polarity 15 (Default: Normal) Selects the RTTY keying polarity. 16 PSK Tone Frequency (Default: 1500) Selects the PSK tone frequency for PSK reception. 17 MENU » SET > Function > SPEECH 18 SPEECH Language Selects the speech language. SPEECH Speed Selects the speech speed. 19 (Default: English) 20 (Default: Fast) 21 S-Level SPEECH (Default: ON) Turns the S-meter level announcement ON or OFF. MODE SPEECH (Default: OFF) Turns the operating mode announcement ON or OFF. SPEECH Level (Default: 50%) Sets the Voice Synthesizer audio output level. 8-3