Icom IC-7610 Instruction Manual basic - Page 58

8 SET MODE Connectors (Continued) DATA1 MOD DATA2 MOD DATA3 MOD (Default: ACC) (Default: USB) (Default: MIC, USB) Selects the connector(s) to input the modulation signal when the data mode is ON. LTouching the [DATA] key in the MODE screen activates the data mode and does the following: ••In transmit, it locks the transmission pass bandwidth to the default MID (300 - 2700 Hz). ••In receive, it changes the filter selection from the SSB filter set to the CW filter set. (However, you can still adjust the set receive IF filter bandwidths by touching the filter icon for 1 second.) This enables the 1/4 Tuning function setting in the FUNCTION screen. (Disables the Speech Compressor) ••It automatically sets the modulation input to the "MIC," "ACC," "MIC, ACC," "USB," "MIC, USB" or "LAN" connector(s) selected in this item, for all three data modes. MENU » SET > Connectors > USB SEND/Keying USB SEND (Default: OFF) You can control transmit and receive from the PC through the USB port. Selects the control port to be used for communication between the IC-7610 and PC. LYou cannot select the terminal which is already selected in the "USB Keying (CW)" or "USB Keying (RTTY)" item. USB Keying (CW) (Default: OFF) You can control transmit, receive and keying from the PC, through the USB port. Selects the control port to be used for communication between the IC-7610 and PC. LYou cannot select the terminal which is already selected in the "USB SEND" or "USB Keying (RTTY)" item. USB Keying (RTTY) (Default: OFF) You can control transmit, receive and RTTY (FSK) from the PC, through the USB port. Selects the control port to be used for communication between the IC-7610 and PC. LYou cannot select the terminal which is already selected in the "USB SEND" or "USB Keying (CW)" item. MENU » SET > Connectors > External Keypad VOICE (Default: OFF) Enables voice memory transmission using an external keypad. KEYER (Default: OFF) Enables keyer memory transmission using an external keypad. RTTY (Default: OFF) Enables RTTY memory transmission using an external keypad. PSK (Default: OFF) Enables PSK memory transmission using an external keypad. MENU » SET > Connectors > Keyboard/Mouse Keyboard [F1]-[F8] (VOICE) (Default: OFF) Enables the Voice TX memory transmission using a keyboard connected to [USB]. Keyboard [F1]-[F8] (KEYER) (Default: OFF) Enables keyer memory transmission using a keyboard connected to [USB]. Keyboard Type Selects the keyboard language. (Default: English) Keyboard Repeat Delay (Default: 250ms) Sets the repeat delay time of the keyboard. Keyboard Repeat Rate (Default: 10.9cps) Sets the repeat rate of the keyboard. Mouse Pointer Speed Selects the mouse pointer speed. (Default: MID) Mouse Pointer Acceleration (Default: ON) Turns the mouse pointer acceleration ON or OFF. MENU » SET > Connectors > USB DIAL USB DIAL Select (Default: SUB Only) Selects the Sub band or Main and Sub band to operate on the RC-28's main dial. USB DIAL Auto TS (Default: High) Selects the Automatic Tuning Step for the RC-28's main dial. When rapidly rotating the RC-28's main dial, the tuning step is automatically changed according to the rotation speed. USB DIAL [TRANSMIT] Switch (Default: Push to toggle) Selects whether to toggle between transmit and receive by pushing, or to transmit only while holding the [TRANSMIT] key on the RC-28. 8-6