Icom ID-4100A User Manual - Page 18
◇ Attaching to a flat surface, ■ Connecting a microphone, ■ Connecting to a DC powersupply
View all Icom ID-4100A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
1 INSTALLATION AND CONNECTIONS ■■ Installing the controller (Continued) DDAttaching to a flat surface You can install the controller on a flat surface with the optional MBA-8 controller bracket. When attaching the MBA-8 to a wall, use self-tapping screws* (3 mm, 0.12 in (d)). 1. Attach the magnets to the controller. Controller ■■Connecting a microphone Plug in the microphone into the microphone jack on the main unit. Controller Main unit Microphone Screw Magnet Supplied with the MBA-8 2. Attach the MBA-8 to a wall. Self-tapping screw* (3 mm, 0.12 in (d)) When you attach a screw to this hole, use a self-tapping screw* (4 mm, 0.2 in (d)). MBA-8 3. Attach the controller to the MBA-8 that is attached to a wall. * User supplied 3 BASIC MANUAL ■■Connecting to a DC power supply Confirm that the transceiver is OFF, then connect to a 13.8 V DC power source with at least 15 A capacity. RRWARNING! NEVER remove the fuse holders from the DC power cable. CAUTION: DO NOT reverse the polarity when connecting the DC power cable. To an AC outlet DC power supply 13.8 V Red line: + Black line: _ −⊕ Fuses 15 A