Intel SE7505VB2 Product Specification - Page 49
Wake up Sources (ACPI and Legacy), Power Button Off to On, Legacy, Reset Button, NMI Button - 64 bit os
View all Intel SE7505VB2 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
Intel® Server Board SE7505VB2 SE7505VB2 ACPI Implementation The power button input (SW2#) provides PWRBTN_IN signal to the sIO. The power button input behaves differently depending on whether or not the operating system supports ACPI. Power Button Off to On: The sIO may be configured to generate wakeup events for several different system events: Wake on LAN*, PCI Power Management Interrupt, and Real Time Clock Alarm are examples of these events. Since the processors are not executing, the BIOS does not participate in this sequence. The sIO provides ONSTL# signal to the power supply. The ICH4 and receive power good and reset and then transition to an ON state. Power Button On to Off (Legacy): Power Button On to Off (ACPI): Reset Button: NMI Button: The ICH4 is configured to generate an SMI due to a power button event. The BIOS services this SMI and sets the state of the machine in the ICH4 and sIO to the OFF state. If an ACPI operating system is loaded, the power button switch generates a request (via SCI) to the OS to shutdown the system. The OS retains control of the system and determines what sleep state (if any) the system transitions to. The reset button will generate a hard reset to the system. The NMI button will force an NMI to the processors. 7.1.2 Wake up Sources (ACPI and Legacy) The baseboard is capable of wake up from several sources under a non-ACPI configuration, such as when the operating system does not support ACPI. The wake up sources are defined in the following table. Table 19. Supported Wake Events Wake Event Power Button Ring indicate from serial1 Ring indicate from serial2 PME from PCI 32/33 PME from PCI secondary 64/100 PME from primary PCI 64/66 RTC Alarm Mouse Keyboard USB Supported via ACPI (by sleep state) Always wakes system S1, S4, S5 S1, S4, S5 S1, S4, S5 S1, S4, S5 S1, S4, S5 S1, S4 S1 S1 S1 Supported Via Legacy Wake Always wakes system S5 S5 S5 S5 S5 No No No No Under ACPI, the operating system programs the ICH4 and sIO to wake up on the desired event, but in legacy mode, the BIOS enables/disables wake up sources based on an option in BIOS Setup. The operating system or a driver must clear any pending wake up status bits in the associated hardware (such as the Wake on LAN status bit in the LAN application specific integrated circuit (ASIC), or PCI Power Management Event (PME) status bit in a PCI device. The legacy wake up feature is disabled by default. Revision 1.2 49 Intel part number C32194-002