Invacare M61 Owners Manual - Page 50

SECTION 9-FRONT RIGGINGS Model PH904A and PHAL4A NOTE: For this procedure, refer to FIGURE 9.3. NOTE: PH904A style front rigging shown. PHAL4A front rigging adjust the same way. 1. Loosen, but do not remove the lug bolt and locknut that secure the lower footrest to the footrest support. 2. Reposition the lower footrest to the desired height. Footrest Support Lug Bolt Locknut 3. Securely tighten the lug bolt and locknut that secure the lower footrest to the footrest support. 4. Repeat STEPS 1‐3 for the opposite side of the wheelchair footrest, if necessary. Lower Footrest FIGURE 9.3 Adjusting Footrest Height Model PH904A and PHAL4A Replacing Heel Loops NOTE: For this procedure, refer to FIGURE 9.4. 1. Note the position of hex bolt, coved washers and locknut for reinstallation. Locknut Coved Washer 2. Remove the hex bolt, coved washers and locknut that secure the lower footrest to the footrest support. 3. Remove the lower footrest. 4. Remove the phillips bolt, spacer and locknut that secure the existing heel loop to the lower footrest. Coved Washer Footrest Support Lower Footrest Hex Bolt Phillips Bolt Spacer Heel Loop 5. Slide the existing heel loop off the lower footrest. Locknut 6. Replace heel loop. 7. Reverse STEPS 1‐6 to reassemble. FIGURE 9.4 Replacing Heel Loops NOTE: When securing heel loop to lower footrest, tighten the phillips screw and locknut until the spacer is secure. Pronto® M51™and M61™with SureStep® 50 Part No 1125085