JVC GY-DV550E Instruction Manual - Page 50

6. SETTING AND ADJUSTMENTS BEFORE SHOOTING 6-9 Audio Input Signal Selection VF PUSH OFF ZEBRA SKIN AUTO ON AREA WHITE ACCU FOCUS VTR AUDIO TAKE LEVEL CH-1 AUDIO IN FRONT connector FILTER 1 3200k 2 5600k+1/8ND 3 5600k+1/64ND SHUTTER STATUS MENU ALARM MONITOR AUTO IRIS FULL AUTO BLACK BACK L NORMAL SPOT L STRETCH NORMAL COMPRESS LOLUX VTR GAIN OUTPUT WHT.BAL NG OPERATE ON OFF OPERATE/WARNING RESET MONITOR SELECT CH-1 MIX CH-2 LIGHT ON OFF COUNTER CTL TC UB CH-1 AUDIO CH-2 LEVEL CH-1 CH-2 AUTO MANUAL AUDIO SELECT CH-1 CH-2 FRONT REAR AUDIO INPUT MODE RM VTR INCOM MIC CARBON DYNAMIC INCOM MIC ON LEVEL OFF CALL RM OFF DC IN /BATT. POWER AUDIO IN REAR LINE/MIC switch DV LINE EARPHONE DC OUTPUT MIC +48V ON LINE MIC +48V ON FRONT AUDIO IN REAR INTERCOM DC INPUT AUDIO IN FRONT LINE/MIC switch CH-1 AUDIO INPUT switch CH-2 AUDIO INPUT switch CH-1 AUDIO CH-2 LEVEL CH-1 CH-2 AUTO MANUAL AUDIO SELECT CH-1 CH-2 FRONT REAR AUDIO INPUT AUDIO IN REAR connector The GY-DV550 is provided with the AUDIO INPUT connector on the front section and the AUDIO INPUT connectors at the rear section for audio input. Two channels of sound can be recorded on the tape in digital PCM format. Using the AUDIO INPUT switch, select for each channel (CH1 and CH2) whether the sound to be recorded should be the sound from the AUDIO INPUT connector on the front section or the sound from the AUDIO INPUT connectors on the rear section. Selecting the CH-1 channel input sound Make the selection using the CH-1 AUDIO INPUT switch. FRONT : The sound from the AUDIO INPUT connector on the front section is recorded on the CH-1 channel. REAR : The sound from the AUDIO INPUT connector on the rear section is recorded on the CH-1 channel. Selecting the CH-2 channel input sound Make the selection using the CH-2 AUDIO INPUT switch. FRONT : The sound from the AUDIO INPUT connector on the front section is recorded on the CH-2 channel. REAR : The sound from the AUDIO INPUT connector on the rear section is recorded on the CH-2 channel. Selection of front audio input and rear audio input connectors Select the audio signal input to the AUDIO IN FRONT and AUDIO IN REAR connector using the [LINE/MIC] switch. Make settings for the AUDIO IN FRONT and AUDIO IN REAR connectors separately. LINE : Set to this position when connected to audio equipment, etc. The reference input level is +4 dBs. MIC : Set to this position when using a monaural microphone. The reference input level is -60 dBs. MIC +48 V : Set to this position when a microphone (phantom microphone) requiring +48 V DC power supply is connected. CAUTION: When connecting a component that does not require +48 V power supply, make sure that the LINE/MIC switch is not set to MIC +48V. Neglecting this could cause damage to the connected component. 50